左铭,杨养花,张志述.锯齿冠低压涡轮工作叶片叶冠防错位设计方法[J].航空发动机,2018,44(3):36-41
锯齿冠低压涡轮工作叶片叶冠防错位设计方法
Dislocation Preventing Methods of Shroud Shaped Saw Toothof Low Pressure Turbine Blade
  
DOI:
中文关键词:  锯齿冠:低压涡轮工作叶片  预防错位  航空发动机
英文关键词:saw tooth shaped shroud  low pressure turbine blade  cause analyses and dislocation preventing methods  aeroengine
基金项目:航空动力基础研究项目资助
作者单位E-mail
左铭,杨养花,张志述 中国航发沈阳发动机研究所沈阳110015 zuoming1984@sina.cn 
摘要点击次数: 909
全文下载次数: 832
中文摘要:
      针对锯齿冠低压涡轮工作叶片在使用过程中发生的叶冠错位故障,在综合分析各次叶冠错位故障发生原因的基础上, 总结了锯齿冠低压涡轮工作叶片叶冠错位模式,绘制了模式图,并针对各种叶冠错位模式提出了1 套完整的锯齿冠低压涡轮工作 叶片预防叶冠错位的设计方法。在2 型发动机上进行应用的结果表明,本方法是切实可行的。
英文摘要:
      Aiming at the failure of Saw tooth shaped shroud dislocation caused by the operation of low pressure turbine working blade, based on a comprehensive analysis of the causes of each dislocation fault, the dislocation pattern of the saw tooth of pressure turbine working blade was summarized, and the model chart was drawn. Then blad complete design method was proposed to prevent the Saw tooth shaped shroud dislocation of the low pressure turbine. The application results on two different type engine show that this methods is feasible.
查看全文  查看/发表评论  下载PDF阅读器
关闭