| 高志坤，迟庆新，卜嘉利.某涡轮后机匣裂纹失效机理分析[J].航空发动机,2018,44(6): |
| 某涡轮后机匣裂纹失效机理分析 |
| Study on the Crack Failure Mechanism of a Turbine Rear Casing |
| |
| DOI： |
| 中文关键词: 涡轮后机匣 裂纹 疲劳 铸造缺陷 再结晶 故障分析 航空发动机 |
| 英文关键词:turbine rear casing crack fatigue casting defect recrystallization failure analysis aeroengine |
| 基金项目:航空动力基础研究项目资助 |
|
| 摘要点击次数: 1709 |
| 全文下载次数: 1248 |
| 中文摘要: |
| 为排除某航空发动机斜支板涡轮后机匣在试车后出现裂纹的故障，进行了裂纹宏观检查、断口宏观和微观形貌分析、材
质检查、细晶层成因及其对疲劳特性影响分析，并对裂纹性质进行了判定，分析了产生裂纹故障的原因。结果表明：斜支板涡轮后机
匣裂纹为疲劳性质，原始铸造冷隔缺陷、热等静压工艺产生的细小再结晶层、基体晶粒粗大是促使涡轮后机匣过早疲劳开裂的主要
原因。为避免该类故障再次发生，建议提高浇注温度以增强浇注液流动性，从而排除冷隔缺陷；防止热等静压时产生表面细小再结晶；添加细化剂使基体晶粒细化 |
| 英文摘要: |
| In order to eliminate the crack fault on the turbine rear casing with tilted-plat,the macroscopic crack and material quality
were inspected,the macroscopic and microscopic morphology fracture were analyszed,the origin of fine crystal layer and its influence on
fatigue characteristics were analyzed. The crack characteristic was judged and the reason of crack fault was analyzed. The results show that
the crack on the turbine rear casing with tilted-plat is fatigue crack,the original casting cold barrier defect,the fine recrystallization layer
produced by hot isostatic pressing process,and the coarse matrix grain are the main causes of premature fatigue cracking of turbine rear
casing. It is suggested that the pouring temperature should be raised to enhance the fluidity of the casting solution so as to eliminate the cold
barrier defect,to prevent the formation of fine recrystallization on the surface during hot isostatic pressing,and to add refiners to refine the
matrix grains. |
| 查看全文 查看/发表评论 下载PDF阅读器 |