刘欢,张开阔,佟文伟,李艳明.DD6 合金涡轮叶片裂纹失效分析[J].航空发动机,2020,46(6):87-91
DD6 合金涡轮叶片裂纹失效分析
Crack Failure Analysis of Turbine Blade of DD6 Alloy
  
DOI:
中文关键词:  失效分析  涡轮叶片  镍基单晶高温合金  DD6  再结晶  航空发动机
英文关键词:failure analysis  turbine blade  nickel based single crystal superalloy  DD6  recrystallization  aeroengine
基金项目:航空动力基础研究项目资助
作者单位E-mail
刘欢,张开阔,佟文伟,李艳明 中国航发沈阳发动机研究所沈阳110015 lhstef@126.com 
摘要点击次数: 1305
全文下载次数: 782
中文摘要:
      为了确定DD6 合金涡轮叶片在工作过程中叶身排气窗处产生的裂纹的性质和产生原因,对裂纹叶片进行了外观检查、 断口分析、成分分析和组织分析。结果表明:DD6 合金涡轮叶片裂纹是叶片排气窗间隔墙内腔转接部位再结晶引起的疲劳开裂,再 结晶晶粒产生于叶片生产过程中固溶处理之后;叶片其他排气窗间隔墙内腔表面存在小裂纹,是在叶片生产过程的再结晶检测工 序中腐蚀液流进内腔侵蚀再结晶晶粒边界所致;并通过模拟试验再现了再结晶晶粒和小裂纹的产生。提出了增加叶片内腔再结晶 检测控制、改进叶片排气窗结构或铸造工艺的建议。
英文摘要:
      In order to clarify the properties and causes of crack occurred on trailing edge of turbine blade of DD6 alloy ,the appearance inspection,fracture analysis,composition analysis and microstructure analysis of the cracked blades were carried out. The result show that the crack of the turbine blade of DD6 alloy is fatigue cracking caused by recrystallization at the boundaries of the blade trailing edge partition wall,and the recrystallized grain is produced after the solid solution treatment during the blade production. There are small cracks on the inner surface of the other trailing edge partition wall of the blade,which is caused by the erosion of the recrystallized grain boundary by the flow of corrosion liquid into the inner cavity during the recrystallization detection process of the blade production process. The production of recrystallized grains and small cracks are reproduced by simulation test. The suggestions of increasing the detection and control of cavity recrystallization and improving the structure of trailing edge or casting process are put forward.
查看全文  查看/发表评论  下载PDF阅读器